EU Infrared Wall Smart Light Switch
Product selling points:
1. Infrared sensing, no need to touch the switch
2. Avoid bacterial cross infection for greater safety
3.15cm sensing distance to avoid misoperation
4. Tempered protective glass panel, scratch resistant, easy to clean
Main specifications:
Input voltage: AC100-240V 50/60Hz
Wiring: live and neutral wires
Maximum load current: 10A
Rated Power:1000W
Infrared sensing distance less than or equal 15cm
Installation:
1.Disassemble the original switch from the the wall.
2.For the infrared sensor switch, you need to take off the control part from the switch panel by a small tool.
3.Loose the four screws and wire the switch with the live line and neutral line.
4.Cover the panel on the switch.
Note:
The power supply must be cut off during installation.
Neutral wire required.
The total load does not exceed 1000W.
This infrared sensor switch is applied to replace traditional or old switch panels.lt can be directly installed at the place where the original switch lay. You can control the light without touch the switch. When your hand close to the switch in the range of 15cm, the light can turn on immediately.